4X4 Adventurer Grey Cloth Seats + Adaptors for Mitsubishi Triton MN-ML 2005-16

Autotecnica Adventurer 4X4 Seat Cloth Grey S1

2x Seats

with

Adaptors for

Mitsubishi Triton MN ML 2005-16

NOTE: THE ADAPTORS WILL ONLY SUIT ABOVE MODELS WITH REMOVABLE SLIDERS FROM THE ORIGINAL SEAT. 

Seat Height adjuster cannot be used with this conversion.

This rail is not suitable for Mitsubishi Triton vehicles with airbags installed into the seats.

This rail is not suitable for Mitsubishi Triton vehicles with bench seats.

This rail is not suitable for Mitsubishi Triton vehicles with rivets holding the seat and original rail together.

Prior to purchasing please remove a current seat from your vehicle and check the seat mount is the same as shown in the photo of the original.

12-month Warranty from Autotecnica

Adventurer Series Seats

• Quick forward reclining tilt lever
• Dual mech adjusters
• Rear storage pocket
• Fixed Headrest
• ADR Compliant
• includes Seat Adaptors for Mitsubishi Triton MN models. Left and Right brackets with bolts and spacers as required. See picture. Uses your existing floor seat mounting holes and bolts, and original seat slides.

Dimensions:

• Shoulder: 550mm
• Height: 890mm
• Depth: 550mm
• Width: 540mm
• Mounting holes - 385mm wide; either 255mm front to rear or 305mm front to rear (in other words there are two mounting holes at the rear of the seats 50mm apart approx)

Available in 4 Styles:

• Grey Cotton
• Black Cotton
• Black PU Leather with Lumbar Support Adjuster
• Grey PU Leather with Lumbar Support Adjuster

Mitsubishi Triton Seat Adapter Plate ML-MN 2006-15

• To Suit ML and MN Triton
• Suits the vehicle's original seat adapter bolting holes
• All fitting hardware supplied
• Fitting instructions supplied

*Please note: This rail is not suitable for Mitsubishi Triton vehicles with airbags installed into the seats.

• This rail is not suitable for Mitsubishi Triton vehicles with bench seats.
• This rail is not suitable for Mitsubishi Triton vehicles with rivets holding the seat and original rail together.
• This is just an adapter plate. If you have the rails stuck to the original seat please use part number 693
• Due to the style of some Autotecnica seats when fitted it could raise the front to bolster up to 20mm from stock vehicle height. 

Available Pick-up: Factory 4, 10 Gateway Drive, Carrum Downs, Vic 3201